The 19ht Taiwan
SMEs Innovation Award
Home > Products > Drill Grinder & END Mill > END Mill & Drill Cutter
END Mill & Drill Cutter
Easy to operate, no experience required for cutting a precise tool.
For CBN Wheel
|SG High Speed Drill||Titanium Coated Drill|
|Straight Shank Drill||HSS END Mill|
For CBN Wheel
|Carbide END Mill|
1. Install the power cord on the cutter.
2. Put the machine on a hard, level surface then install the handle on the base.
***as shown on diagram #1
3. Lock the valve connector, then insert the pressurized blast connector into the air pressurized cooling system. Insert the collet holder with drill and turn right, then tighten the drill by collet holder for set up the grinding position.
***as shown on diagram #2
4. Select the proper wheel and diameter of end mill Ø3mm~Ø16mm, put the end mill (drill) horizontally into the groove from right to left. Adjust the proper length for cut and tighten the base with Ø10mm Allen Key.
Note: The machine is adjusted before dispatched. Don't adjust
5. Switch on the machine.
6. Switch on the cooling system.
Note: The usage life will be decreased if don't switch on the cooling system.
7. Hold and raise the handle to cut off the end mill (drill).
***as shown on diagram #5
8. Switch off the machine.
9. Switch off the cooling system.
10. Loosen the base with 10mm Allen Key, then take out the end mill (drill)
***as shown on diagram #6
11. Be sure to do every cleaning and maintenance well to maintain the usage life.
Note: Please switch off the machine while replacing the wheel to ensure the security!